Rubicon Trail v 1.1

This was the track in Jeep 4x4 Evo 2 and Just converted it over. It works in Free Mode and Quick Race.  

Installation-Just unzip Rubicon.pod into your 4x4evo2 dir and open pod.ini with a text editor like the one you are reading now.
At the top there is a number. Add 1 to it.  Then scroll down to the bottom and put at the very end "Rubicon.pod" 
(without the "s). Then it should work in 4x4evo2. 

New add-ons from Version 1.0 (Never uploaded v 1.0) 
-Works both in Free and Quick Race Mode(Only one lap in quick race and no opponents)
-Small bugs when you run into stuff
-Added check points so you can now finish the race in quick mode
-Other small changes
-Uploaded the Map :)

This track was not altered drastical and only a few rocks were removed because it would come up with an error that said
there are to many complex collsion objects.  This map to me about 10 hours to make and is 
my second track for 4x4 Evo 2. My other track is the Moab Trail that I also converted from Jeep evo2.

Try to finish the track below 10 minutes. It is hard.

and ?'s or suggestions e-mail me at- Jacir20@hotmail.com

Jacir20

Save a tree,
Eat a Beaver.

This track was made by Tri and was origanally in Jeep4x4 evo2.  It was not made by me, only converted and a little edited by
me. Don't give me very much credit.
 